Mercedes Sprinter Third Brake Light Camera | OEM-Style Rear View Backup Camera

PRODUCT INTRODUCTION

Item number: ST-1766S-2

Mercedes Benz Sprinter 2006-2023/VW Crafter 2007-2017 3rd brake light camera

Products Description:

Upgrade your vehicle safety with the Standtop Mercedes Sprinter 3rd Brake Light Camera. Specifically designed for the l Sprinter models (2006-2023), this high-mount backup camera replaces your factory brake light lens for a clean, OEM-style installation.

Whether you are navigating a crowded city street or reversing a large Sprinter Camper Van, our camera provides a crystal-clear, bird's-eye view of the rear, eliminating dangerous blind spots and protecting your investment.

AHD or CVBS signal optional

Key Features & Benefits

Seamless OEM Integration: Replaces the third brake light housing perfectly. No drilling or new holes are required, preserving your vehicle's exterior integrity and resale value.
AHD 1080P or 700TVL Ultra-Clarity: Equipped with a high-performance sensor, delivering sharp, vivid images with a resolution of 1920x1080 pixels (AHD) or 700TVL
170° Super Wide Angle: Features a premium 6-layer glass lens that covers the full width of the vehicle and the area directly behind the bumper—ideal for hitching trailers.
Superior Night Vision: Integrated high-power IR LEDs provide excellent visibility in total darkness, ensuring safe parking 24/7.
IP68 Waterproof Rating: Fully nano-glued and sealed to withstand high-pressure car washes, heavy rain, and extreme temperatures (-30°C to +70°C).
Adjustable View: The camera lens can be tilted vertically to achieve the perfect viewing angle for your specific Sprinter setup.

Product Specs:

Image Sensor : 1/3" Sony CCD or 1/2.9" CMOS
Resolution(HD): 700TVL or AHD 1080p
System: PAL /NTSC
Power supply: DC 12 V
IR Led:6pcs
View Angle:≥170°
Minimum lumination: 0.1Lux
S/N Ratio: ≥48db
Impact rating: 10G
Waterproof : IP68
Operation Tamperature: -30°~70°C Rh95%
Extremely strong weather proof casing
special size for replacement brake light case
4pin connector/RCA connector are optional

Product Applications:

Mercedes Sprinter 2006-2023/VW Crafter 2007-2017

Installation Guide: 3-Step Setup for Sprinter Brake Light Camera:

Step 1: Remove the Factory Brake Light

Locate: Use a T25 Torx screwdriver to remove the two screws securing the original third brake light lens at the top rear of your Mercedes Sprinter.
Disconnect: Gently pull the lens out and unplug the factory power connector from the light bulb/LED strip.
Clean: Wipe the mounting area to ensure a watertight seal for the new camera housing.

Step 2: Route the Video Cable

Through the Roof: Thread the 10-meter (or 15m) aviation cable through the brake light opening into the vehicle's interior.
Concealment: Run the cable along the roofline or floor edge, hidden behind the interior trim panels, all the way to the dashboard/monitor location.
Power Connection: * Connect the camera's power wires to the Reverse Light circuit (DC 12V) so the camera activates automatically when you shift into reverse.
- Tip: Red to Positive (+), Black to Ground (-).

Step 3: Mount the Camera & Test

Plug & Play: Connect the new camera's connector to the routed video cable. Reconnect the original brake light power plug to the new camera's integrated LED strip.
Secure: Push the camera housing into the original slot and tighten it using the original screws.
Final Check: Turn on the ignition, shift into Reverse, and check the monitor for a clear 1080P image. Adjust the camera lens angle if necessary to see your rear bumper or hitch